-
18
Jun, 2021
To ensure the accurate reproduction of the dots of each tone level of the printing plate, each dot on the printing plate must be accurately inked.
-
17
Jun, 2021
Ensure The Closedness Of The Ink Supply System
Ensure that the ink supply system is closed, and it is best to install a filter device (120 mesh or 140 mesh) at the ink inlet, which is very necessary.
-
16
Jun, 2021
Correct Daily Cleaning And Maintenance Of Anilox Roller
Daily cleaning of steel wire brush: first wipe the ink with a solvent, and then use a special chemical cleaning agent to clean the mesh with a special stainless steel wire brush...
-
15
Jun, 2021
Do not over-pressurize the doctor blade in order to get more tones, so as to increase the wear of the anilox roller and the doctor blade.
-
14
Jun, 2021
Loading And Unloading Of Anilox Roll
Do not fix the hoisting rope directly on the roller surface to lift the mobile roller, so as to avoid the roller flower falling and breaking when lifting.
-
13
Jun, 2021
The anilox roll package is stored in a dry place indoors to prevent damage due to moisture, rain and direct sunlight.
-
12
Jun, 2021
Maintenance Method Of Anilox Roller
Use special cleaning fluid. There are many kinds of special cleaning fluids on the market, which can re-wet the ink that has dried up at the bottom of the cell, and clean it in ...
-
11
Jun, 2021
Do A Good Job Of Cleaning The Anilox Roller
There must be sufficient cleaning time. If the ink accumulated at the bottom of the cell is not dry, it can be dissolved in water, but because it is surrounded by the mesh wall ...
-
10
Jun, 2021
Forbidden To Scrape, Bump Or Bump The Anilox Roller
In the process of daily use, do the following: Keep the equipment clean. Anilox rollers and rubber rollers are generally equipped with safety shields.
-
09
Jun, 2021
Reasons For The Protection Of Anilox Rollers
In the printing process, due to the effect of the doctor blade, the anilox roller will be worn to a certain extent.
-
08
Jun, 2021
Left And Right Movement Of The Anilox Scraper
The left and right movement of the scraper has an important role in supporting the scraping line, improving the utilization of the scraper, and reducing the wear on the anilox r...
-
07
Jun, 2021
The Flatness Of The Anilox Scraper
The flatness of the squeegee means that there is no warping deformation, and the coating amount is uniform, otherwise the coating amount difference will become larger.
