The Flatness Of The Anilox Scraper

The flatness of the squeegee means that there is no warping deformation, and the coating amount is uniform, otherwise the coating amount difference will become larger. The flatness of the squeegee depends on the method of installing the squeegee. Of course, it may also be related to the sticking of foreign matter in the slot of the knife holder or on the blade and lining. Therefore, when installing the knife, clean the lining and place the new knife behind the lining. Load into the slot. The screw on the back of the blade should be tightened first from the middle of the blade, and then gradually tightened to the two sides, and the two sides should be tightened by the wheel. In order to prevent the blade from warping, the screw should be tightened two or three times. While screwing the screw, take a piece of cloth to clamp the blade and the lining, and forcefully tighten it to one side, so that the finished knife is relatively flat. In order to ensure that the coating amount is within the standard range of the difference.