Left And Right Movement Of The Anilox Scraper

The left and right movement of the scraper has an important role in supporting the scraping line, improving the utilization of the scraper, and reducing the wear on the anilox roller. From this point of view, the mesh wall is less worn, the mesh is relatively deep, and the fluid part is contained, which is beneficial to achieve The amount of coating required. After discussing the optimal coating amount of the aluminum foil substrate and the adhesive, the aluminum foil and the PVC hard sheet are heat-sealed, and the bonding strength of the two after heat-sealing is usually measured by the heat-sealing strength of the adhesive layer. In a certain range, the heat seal strength of aluminum foil and PVC is proportional to the coating amount, but after reaching a certain level, it is not proportional. In most test cases, the coating amount is 3-6g/cm^2. Heat seal strength requirements. If the coating amount is increased, after the heat seal strength value increases to a certain value as the coating amount increases, the heat seal strength curve tends to be balanced, and the strength change is small. Therefore, it is not necessary to increase the coating amount of the adhesive. increase cost.